|
|
|||||||
| Home | Forum | Online Store | Information | LJ Webcam | Gallery | Register | FAQ | Community | Calendar | Today's Posts | Search |
 |
|
|
Thread Tools | Display Modes |
|
|
05-30-2016, 05:40 PM
|
#1 |
|
Carlisle
Join Date: Aug 2013
Location: San Diego
Posts: 206
|
Buy a 1" wide x 1/4' thick aluminum bar from Home Depot. Use a hacksaw to cut to approximately 3" length. Drill holes to line up with Ram mount, and install with 1/4" x 1" stainless steel bolts and nylon lock nuts.
__________________
<iframe width="560" height="315" src="https://www.youtube.com/embed/NTOZ1JOXUkQ" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe> |
|
|
|
05-30-2016, 07:58 PM
|
#2 |
|
Senior Member
Join Date: Mar 2011
Location: Santa Ana/Westminster
Posts: 1,256
|
Recentlymade my own out of high density pastic I got at a plastic shop. Probsvly 10 cent worth from their scrap bin.
__________________
Kevin Yellow PA12 |
|
|
|
|
05-30-2016, 09:48 PM
|
#3 | |
|
Senior Member
Join Date: Jul 2013
Location: San Diego
Posts: 149
|
Quote:
Thanks. I bought some stainless hardware while I was at West Marine today. I was thinking about bending or filing the washers, as the kayak hull starts to slope down right outside the holes. But this sounds like a good plan for the backing. Thanks.
__________________
2008 Olive Hobie Revolution 13 |
|
|
|
|
|
|
|
Hybrid Mode
