Pro anglers and the mirage drive.

[ProfessorLongArms]

Originally Posted by Mahigeer

The first time I used an Outback, I did not know about how to adjust the pedal reach. It was not a good ride.

Then when I learned, it got easier. The taller you are the higher the number setting.

The legs should not be extended full without a bend in the knees.

The angle of the seat back is important too.

I think a test drive at Sunset OEX is a must first step.

Regarding pdeal length, I followed this advice from several other sources. 2017 new model outback. I was “bottoming out” the pedal on each stroke, and after two trips noticed that the tiny Peg that holds the split ring ( The one that holds the fin pins in place) against the body had been completely sheared off, and the split rings had been mangled.

Not sure if that’s a design flaw in this specific year model, or maybe I was just kicking too hard at the end of the full range of motion, but I switched back to a pedal setting slightly longer, and just hold back from Fully straightening my legs. Curious if anybody else has had a similar experience.

[TJones]

Originally Posted by ProfessorLongArms

Regarding pdeal length, I followed this advice from several other sources. 2017 new model outback. I was “bottoming out” the pedal on each stroke, and after two trips noticed that the tiny Peg that holds the split ring ( The one that holds the fin pins in place) against the body had been completely sheared off, and the split rings had been mangled.

Not sure if that’s a design flaw in this specific year model, or maybe I was just kicking too hard at the end of the full range of motion, but I switched back to a pedal setting slightly longer, and just hold back from Fully straightening my legs. Curious if anybody else has had a similar experience.

.

[YakDout]

Originally Posted by ProfessorLongArms

Regarding pdeal length, I followed this advice from several other sources. 2017 new model outback. I was “bottoming out” the pedal on each stroke, and after two trips noticed that the tiny Peg that holds the split ring ( The one that holds the fin pins in place) against the body had been completely sheared off, and the split rings had been mangled.



Not sure if that’s a design flaw in this specific year model, or maybe I was just kicking too hard at the end of the full range of motion, but I switched back to a pedal setting slightly longer, and just hold back from Fully straightening my legs. Curious if anybody else has had a similar experience.

You should change your username to ProfessorLongLegs