Plano Box for Prowler 13 - Kayak Fishing Adventures on Big Water’s Edge

prowlerdude · 10-06-2008, 03:39 PM

Here is what I did. I got a diamond mount for the rail and put the FF there and then put a RAM revolution in the middle spot. I also have the "tub" also. I used cut outs from an old ("Honey have you seen the cutting board") cutting board as backing for strength. I run the fishfinder off rechargeable AA batteries and keep them in a small drybag. I mounted the transducer in goop and have had no problem.

Hope this helps

Mike

10-06-2008, 03:39 PM	#5
prowlerdude Senior Member Join Date: May 2007 Location: Clairemont Posts: 116	Here is what I did. I got a diamond mount for the rail and put the FF there and then put a RAM revolution in the middle spot. I also have the "tub" also. I used cut outs from an old ("Honey have you seen the cutting board") cutting board as backing for strength. I run the fishfinder off rechargeable AA batteries and keep them in a small drybag. I mounted the transducer in goop and have had no problem. Hope this helps Mike