![]() |
|
![]() |
#1 |
Administrator
Join Date: Mar 2005
Location: 1-2 miles off the point
Posts: 6,948
|
Hobie livewell switches are prone to failure over time. I'd disconnect battery and cut out the switch and see if it works then, Switches run $15
__________________
![]() ![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Sep 2010
Location: South OC
Posts: 1,606
|
|
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: Aug 2012
Posts: 1,823
|
Put the switch in a bowl of rice
__________________
"Beware the lollipop of mediocrity; lick it once and you’ll suck forever." — Brian Wilson |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Sep 2011
Location: San Diego
Posts: 901
|
I direct connect, no switch for me.
Ebay is your friend ..... |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Jun 2014
Location: East County San Diego
Posts: 657
|
Same.
My old DIY bait tank had a very nice waterproof toggle switch housed in the pelican case and this never failed, but on my hobie after three bad switches, I just bypassed the switch and went straight to the battery. Problem solved. |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: May 2016
Location: SANTUCKET
Posts: 629
|
DIDO
There's only one good place for that switch, the trash!
|
![]() |
![]() |
![]() |
#7 |
Senior Member
Join Date: Jun 2014
Posts: 423
|
Agree on cutting out the switch. Use a shrink tube connector or a wire nut filled with dielectric grease. If you really like having a switch, you could get a livewell v2 switch and mount it on the side of your tank in the highest flattest section you can find. The V2 switch is far superior.
|
![]() |
![]() |
![]() |
|
|