Mounting a transducer - HELP! - Kayak Fishing Adventures on Big Water’s Edge

Podaker · 12-28-2009, 10:54 PM

I used a two part slow cure epoxy recommended by billy v and have had no problems in over a year. previously I had a piece of foam fitted to hold the transducer under water and after the boat rolled or pitched the water would find a way out resulting in loss of signal. lots of people use marine goop or other epoxy's. my advise is whatever you use make sure once you set it be sure it sets long enough to dry completely and don't mess with it.

12-28-2009, 10:54 PM	#6
Podaker Member Join Date: Aug 2008 Location: la jolla shores Posts: 86	I used a two part slow cure epoxy recommended by billy v and have had no problems in over a year. previously I had a piece of foam fitted to hold the transducer under water and after the boat rolled or pitched the water would find a way out resulting in loss of signal. lots of people use marine goop or other epoxy's. my advise is whatever you use make sure once you set it be sure it sets long enough to dry completely and don't mess with it.