Help with battery box

[lterrero]

Originally Posted by cowboybill

Hey Farrier, I use dialectric grease like toothpaste.....every connection, even inside the battery box...

On my new connections, like inside the plug, I jam dialectric inside, then put any booties over the outside, then seal outside with marine goop...let dry, and then outer coat external connections with more dialectric

Every 5-7 trips, I clean and re-grease just the outside connections.

after about a year, my connections look like brand new...

I think I got the grease at an autosupply place in a huge tube about the size of marine goop
cowboybill

But what can save? my connectors and wires from Electrolysis; at least about every 5 month have replace wire & connectors.

[FARRIER]

Yeah wahoo i had the same prob as you. and my hot wire is corroded well past repair which means im going to have to re order a new set for the transducer here eventually. probably gonna be easier to replace the unit with a better one! well lesson learned for me. its tough learning such expensive lessons some times.

[maui jim]

Why use those connectors?? I water tight the cord thru the box and eliminater that problem. I just unplug the battery from the inside the box,(which is stowed below deck) after the day of use open the batery box, and air dry overnight , been using this system over a year and not 1 sign of corosion ,even from the battery. I use a different dry box than Pelican and it's way cheaper and watertite..( after all your not exposing it to any great depths or elevations, just some splashed water and dampness) I use the greese on the above deck connection bi-weekely and no sign of corrosion there either.
When I add a light for nite adventures I simply run the wire thru the same opening on the box and no leaks, and no corrision on the switch, installed above deck for light and sealed with 3M 5200 marine grade sealant fast cure. simple........

[Mad Daddy]

Originally Posted by lterrero

But what can save? my connectors and wires from Electrolysis; at least about every 5 month have replace wire & connectors.

After I strip the coating off the wire I put a drop or two of the corrosion block onto the wire and it seeps down between the wires under the coating. I have to admit that I am new to the highly corrosive salt water environment but the stuff has worked very well for me on all of my things that are subjected to wet environments including my boat which has only been in fresh water. I did check my connector to my battery box in my kayak which has only been used in salt water for two months and they look brand new. I have but did not use the dielectric grease because it is messy. I also let a drop soak into all the rivets on my rod holders and various screws on my kayak to give them added protection after I noticed some brown areas on the washers holding on my handles.