Mounting Humminbird transducer in Stealth 14?

[dsafety]

Originally Posted by BrokeLoser

Do you have a link to a thread discussing the grease method? I'm hoping to find some detailed info and instructions.
Also, in the stealth, I'm having trouble finding a spot in the front of the hull that is flat enough to mount the ducer pointing straight down?

Thanks

There is not much to it. I think I wrote some instructions a while back. You might find them if you search for "grease mount".

Basically, you need to create some sort of a "well" to hold the transducer in place. Some folks have reported good luck with using a piece of foam. Spread a thick layer of marine grease over the bottom of your xducer making sure that there are no air bubbles. Gently push the transducer into the well until it seats with the hull. Anchor the xducer with some kind of strap, (velcro, bungie, etc), and you are done.

I don't think that it is very important that you mount on a flat part of the hull. The grease will fill any empty areas. It is probably important that you have the xducer pointed straight down and not to the side, front or back to any large degree.

Bob

[BrokeLoser]

Originally Posted by dsafety

There is not much to it. I think I wrote some instructions a while back. You might find them if you search for "grease mount".

Basically, you need to create some sort of a "well" to hold the transducer in place. Some folks have reported good luck with using a piece of foam. Spread a thick layer of marine grease over the bottom of your xducer making sure that there are no air bubbles. Gently push the transducer into the well until it seats with the hull. Anchor the xducer with some kind of strap, (velcro, bungie, etc), and you are done.

I don't think that it is very important that you mount on a flat part of the hull. The grease will fill any empty areas. It is probably important that you have the xducer pointed straight down and not to the side, front or back to any large degree.

Bob

Thanks Bob...I found your thread on the grease mount method. It sounds like still you prefer the wet well though.
The problem staring me in the face is the fact that the Stealth is so deep V'd in the very front where I'd like to mount the transducer. I'm struggling to figure out how to create a well that sits down in the V nice and snug to allow me to create a 'goop dam' at the base of it.
Has anyone installed one of these in the front of a Stealth using a well?
What did you use and modify to fit down in the V to hold the trans?

Thanks guys!

[dsafety]

The wet mount works just as well, it is just a little more difficult to install and if you do it wrong, the water can drain away making the fish finder useless. I am not familiar with your hull design but I doubt that the deep V is an insurmountable problem.

With the wet mount, you have to create a water-tight seal between the well and the hull. Since plastic hulls flex the seal can be easily broken during a rough launch or landing. The well for the grease mount does not have to be waterproof, just enough to hold the transducer in place.

Bob

[Albert]

If your mounting on an X-wing, you might want to consider mounting the transducer on an arm mounted to the side of the X-wing and putting your battery inside. Would make for easier wiring too.

[BrokeLoser]

Originally Posted by Albert

If your mounting on an X-wing, you might want to consider mounting the transducer on an arm mounted to the side of the X-wing and putting your battery inside. Would make for easier wiring too.

I saw that in the "share your innovations' thread but I'm concerned about it getting caught in kelp, wrapping line around it and dealing with it when launching and landing