Hobie's newest cart

[Rabac3898]

Originally Posted by gear junkie

How are you supposed to load the kayak without turning it on it's side?

Bigger question is, How do you take it off your kayak thats loaded with gear with spilling everything?

[Iceman]

One person can remove the cart easily without tipping it to the side, just lift it from the stern and the cart will drop out. To put the cart on with out tipping it to the side you need 2 people.

[kareem korn]

I thought it wasn't good to use the ones that fit in the scuppers?

I like the wheels tho.

[467echo]

looks nice, wish it was cheaper

[FishNinjaY]

Originally Posted by kareem korn

I thought it wasn't good to use the ones that fit in the scuppers?

I like the wheels tho.

I had read that people were making scupper hole wheel carts and using them on fully loaded non-Hobie kayaks, like the Malibus.. and there is a known weak area at the scupper hole sites that can crack and leak. The Hobies, are thicker reinforced plastic around the scupper holes, and are designed to accommodate the Hobie scupper wheel carts. The Hobies are fine with the scupper carts.

There are lots of posts on this topic on the Hobie Forums.

[Iceman]

I thought it wasn't good to use the ones that fit in the scuppers?

Tim, Hobie has a sleeve insert that reinforces the scuppers, they also have a pair of post clamps on the cart that supports the weight on the bottom of the kayak.

[roadx]

is it possible to buy just the frame? i already have the wheels.

[Iceman]

I would guess that you have a Wheeleez Beach cart that has the same tires but not the same wheel. Your wheel goes on a thicker aluminum axle with a hole and a (cotter pin) this cart has a smaller diameter stainless axle and the wheel is held on with a snap ring and a groove in the axle.

[finyak]

Originally Posted by Iceman

Tim, Hobie has a sleeve insert that reinforces the scuppers, they also have a pair of post clamps on the cart that supports the weight on the bottom of the kayak.

Can you show a picture of the post clamps?And how they work.

Frank

[Iceman]

this shows em, an allen wrench tightens them where you want them

[kareem korn]

Originally Posted by Iceman

Tim, Hobie has a sleeve insert that reinforces the scuppers, they also have a pair of post clamps on the cart that supports the weight on the bottom of the kayak.

Cool, I'll check O-side for that cart. Thanks. Those look almost big enough to rig to a bicycle.

[RockyRaab]

I was never able to get the post clamps tight enough to support my fully-loaded Prangler 14. So I cut two pieces of PVC that just fit over the cart tubes - and then two more pieces of PVC that just fit over the first ones, making them twice as thick. I put them on under the post clamps, so the PVC rests on the axle and supports the clamps. I carefully measured the cart posts so that with the PVC spacers installed I still had room to insert the keeper pin into the post top.

Other folks have simply replaced the post clamps with a tennis ball, but that may or may not allow you to still use the keeper pin.

[Hobie-Pedaller]

Originally Posted by Iceman

One person can remove the cart easily without tipping it to the side, just lift it from the stern and the cart will drop out. To put the cart on with out tipping it to the side you need 2 people.

true dat !!!

that's why i have only used my wheels a few times, in 10 yrs of Hobie yakking.
if there is no one else around to help out after landing, then u can never get your yak back onto the wheels.

i always stay out on water until past sunset, then land on a dark beach.
rarely ever anybody else around on a dark beach.
.