Finally got my gopro!

[bwana]

Be careful of those stock mounts. I found my GoPro. I too have been trying to figure the best way and spot to mount mine on my yak.

I was walking a sandbar in Bolsa Chica trying to make bait for a friend when I skirted a dead bird in the water. Just on the other side was something circular in the sand. I dug up a GoPro.

Got it home, recharged the battery and it had 3 underwater videos on it. Apparently it came off during the US Surf Open on the south side of the HB pier. You can hear the jet skis taking the surfers back out. Then it gets stuck under the HB pier.

I found it 3 days later. During its travels it records schools of bait, croakers croaking, a shark mouthing it. It's a testament to the quality of the GoPro product that it continued to work and still does to this day.

I replaced the lens cover on the housing as it was scratch from the sand and I bought a back up battery.

I sent the videos to a friend at the DFG. She is an Environmental Scientist and got a kick out of the croakers and fish in their natural environment not affected by divers filming.

You can see the unedited videos on youtube. WARNING, it's like Where's Waldo as all videos contain a lot of shots of fish and croakers croaking, you just have to keep watching.

I never got around to a condensed version which would make for more enjoyable watching vs. staring at dead water until fish come into view.

http://www.youtube.com/watch?v=kO_Qbfha2fY

A school of bait swims by at the start of this one:
http://www.youtube.com/watch?v=uoPSIm0nKdg

This one starts out with croakers croaking and one swimming by:
http://www.youtube.com/watch?v=nTz4sy9XE-s

[jorluivil]

I follwed Greg's lead and haven't looked back.

http://www.bigwatersedge.com/bwevb/s...ighlight=mount

thread#5

[FISH11]

This is the shorter one I made to use in frt. to get all the face on and holding Fish pictures. I can use the same base and put the longer one if I want from over the sholder shot. The base is the Scotty fish finder mount base it fits any Scotty rod holder deck mount for about $14 the rest is very inexpensive PVC and some stainless steel bolts and nuts. PS> I also think you can use the base that was part of the box the camera came in if You secure the base from the box to a hatch or something else using some pop rivets like are used on eyelets, etc. That gives you 1 extra mount that doesn't stick on.

[nacho66]

Will, here is one I followed. enjoy your new toy. (http://palmettokayakfishing.blogspot...rsion-for.html )

Regards, Nacho

[William Novotny]

I will go get some pvc today and play around a bit. Last night I got creative and made this hand crane from an old 2 piece fishing rod. Don't let how narrow it is fool you, I reinforced the inside with 2 part epoxy, then drilled through and fitted a bolt through with the same threading as the stock thumb screws. Just to be 100% safe I attached a lanyard incase of failure. It has 2 points of adjustment and will be great for getting underwater shots.

[kayachapi]

Around $15 plus paint

[old_rookie]

This works well on PVC tubing http://gopro.com/camera-mounts/roll-bar-mount